The Fluid Reactor Magnetic Water Conditioner is a high-intensity magnetic treatment system engineered for agricultural, irrigation and industrial applications where hardness, mineral scaling and elevated salinity create operational challenges.

Operating at approximately 6000 Gauss, the Fluid Reactor exposes flowing water to a concentrated magnetic field as it passes through the treatment zone. Rather than removing dissolved solids, the system influences mineral crystallisation behaviour. Under magnetic exposure, calcium and magnesium hardness are encouraged to form suspended micro-crystals instead of adhering to pipe walls and fittings.

The practical outcome in suitable water conditions can include:

• Reduced scale adhesion in pipework and pumps

• Lower emitter blockage in irrigation systems

• Improved distribution consistency

• Potential reduction in visible mineral deposition

This makes the system particularly suited to:

• Bore water with elevated hardness

• Irrigation mains and commercial crop systems

• Hydroponic water conditioning

• Livestock water supply

• Garden applications where hardness contributes to leaf burn and soil accumulation

Recommended Water Parameters (Guideline Only)

Water outside these parameters may still be treatable but requires assessment.

Important – Water Analysis Required

Magnetic water treatment is not a blanket solution. Performance is highly dependent on:

• Calcium hardness levels

• Alkalinity and pH

• Silica concentration

• Iron content

• Flow velocity and pipe material

For this reason, water analysis is strongly advised before purchase. We review your bore report or laboratory results to determine whether magnetic treatment is appropriate or whether alternative technologies such as filtration, softening or reverse osmosis should be considered.

We do not recommend purchasing this system without prior consultation.

Earthing Kit – Recommended Upgrade

We strongly recommend pairing the Fluid Reactor with an earthing kit.

Stray electrical currents and static charge within metal pipe systems can interfere with consistent magnetic field interaction. Properly earthing the pipework helps stabilise electrical potential across the system, allowing the magnetic field to operate more consistently and predictably.

In agricultural environments with pumps, VSD drives and long pipe runs, this is particularly important. An earthing kit assists in:

• Reducing electrical interference

• Improving treatment consistency

• Supporting long-term performance stability

The earthing kit is available as an optional add-on and is recommended for best results.

System Scope

This specific listing is for our prime line Fluid Reactor system designed to suit most pipe sizes from 32mm – 100mm and water with a TDS up to 2700 ppm, subject to mineral breakdown analysis.

Water up to approximately 4400 ppm may be treated using a dual-reactor configuration, pending detailed review.

Hydraulic & Installation Guidelines

For optimal performance:

• Install on a straight section of pipe

• Avoid high turbulence immediately at the treatment zone

• Maintain consistent flow velocity

• Install upstream of critical scale-prone equipment where practical

• Continuous-flow systems generally perform better than stagnant storage systems

System selection should be based on peak flow rate and mineral profile, not pipe diameter alone.

Installation & Environmental Protection Notice

The outer casing of the Fluid Reactor is constructed from PE moulded material.

To ensure long-term performance:

• Protect the unit from prolonged direct UV exposure

• Avoid constant moisture saturation

• Do not allow water pooling around the casing

• Install under cover or within a protective enclosure where possible

Excessive moisture exposure and UV degradation over time may:

• Compromise the integrity of the PE mould

• Allow internal magnet oxidation

• Reduce long-term structural durability

Where outdoor installation is required, weather shielding is strongly recommended.

We are not here to simply sell magnetic devices. We are here to help solve water problems with the correct solution for your specific water chemistry and application.